Power module Holybro PM06 V2-14S

Product detailed description

Power module Holybro PM06 V2-14S

The PM06 Power Module supplies clean 5.2V to the flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.

Please Note: 
The XT60 Plug and 12AWG wire that are pre-soldered on the board are rated for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
This PM06 Power Module uses analog data output and is not compatible with the Pixhawk 5X & 6X (Requires a digital PM like PM06D). 

Specifications： 
Input voltage (10S version): 2S-10S
Input voltage (14S version): 2S-14S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Output: DC 5.2V & 3A Max 
Output Max Power: 18W
Voltage Divider: 18.182
Amperes per Volt: 36.364 
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g

Package Includes：
1x PM06 Power Module
1x JST GHR 6pin 1.25mm pitch cable