Power module Holybro PM06D-14S

Product detailed description

Power module Holybro PM06D-14S

PM06D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. It has built-in power distribution, allowing you power your ESC and FC with the same board.
The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with a XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

NOTE

- PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. 
- This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. 

Specifications:

- Input voltage: 2S- 14S
- PCB Cont. Current Rating: 70A
- PCB Burst Current Rating: 120A (<60 Sec)
- Max current sensing: 327A
- Voltage and current monitor with I2C compatible interface 
- Connector Outputs: 5.2V and 3A max 
- Weight: 24.5g

Package includes:

- 1x  PM06D Power Module
- 1x  6pin 2.00mm pitch cable