Stack SpeedyBee F405 V4 BLS 55A 30x30 FC&ESC

Product detailed description

SpeedyBee F405 V4 BLS 55A 30x30 FC&ESC Stack 

Features:
- The compact design fits 30.5 x 30.5mm mounting on various frames.
- Precise control with STM32F405 MCU and ICM42688P gyro.
- Continuous solid current from the SpeedyBee BLS 55A ESC.
- Easy in-flight controller configuration via Bluetooth.
- Compatible with 3S to 6S LiPo batteries.

Specifications:

SpeedyBee F405 V4 30x30 Flight Controller:
MCU: STM32F405
IMU(Gyro): ICM42688P
USB Port Type: Type-C
Barometer: Built-in
OSD Chip: AT7456E chip
BLE Bluetooth: Supported. Used for Flight Controller configuration (MSP should be enabled with Baud rate 115200 on UART4)
WIFI: Not supported
DJI Air Unit Connection Way: Two ways supported: 6-pin connector or direct soldering
6-pin DJI Air Unit Plug: Supported. Completely compatible with DJI O3/RunCam Link/Caddx Vista/DJI Air Unit V1, no wire is needed to be changed
Blackbox MicroSD Card Slot: Compatible with Standard (SDSC) or High Capacity (SDHC) cards under 32GB
Current Sensor Input: Supported (For SpeedyBee BLS 55A ESC, set scale = 400 and Offset = 0)
Power Input: 3S - 6S LiPo (Through G, BAT pins/pads)
5V Output: 9 groups of 5V output
9V Output: 2 groups of 9V output
3.3V Output: Supported up to 500mA current load
4.5V Output: Supported up to 1A current load
ESC Signal: M1 - M4 on the bottom side, M5-M8 on the front side
UART: 6 sets (UART1, UART2, UART3, UART4 (Dedicated for Bluetooth connection), UART5 (Dedicated for ESC telemetry), UART6)
ESC Telemetry: UART R5 (UART5)
I2C: Supported for various sensors
Traditional Betaflight LED Pad: Supported for WS2812 LED controlled by Betaflight firmware
Buzzer: BZ+ and BZ- pad used for 5V Buzzer
BOOT Button: Supported for firmware flashing and LED control
RSSI Input: Supported (named as RS on the front side)
Smart Port / F.Port: Not supported
Supported Flight Controller Firmware: BetaFlight (Default), INAV
Firmware Target Name: SPEEDYBEEF405V4
Mounting: 30.5 x 30.5mm (4mm hole diameter)
Dimension: 41.6(L) x 39.4(W) x 7.8(H)mm
Weight: 10.5g

SpeedyBee BLS 55A 30x30 4-in-1 ESC:
Firmware: BLHeli_S J-H-40
Continuous Current: 55A x 4
Burst Current: 70(10 seconds)
TVS Protective diode: Yes
External Capacitor: 1000uF Low ESR Capacitor(In the package)
ESC Protocol: DSHOT300/600
Power Input: 3-6S LiPo
Power Output: VBAT
Current Sensor: Support (Scale=400 Offset=0)
ESC Telemetry: Not supported
Mounting: 30.5 x 30.5mm( 4mm hole diameter)
Dimension: 45.6(L) x 44(W) x 8mm(H)
Weight: 23.5g