Holybro Remote ID
Code: 18089Product detailed description
Holybro RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module.
The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators.
If you need customization or have special request, feel free to reach out to us via email.
Specification
- Radio module:
- Espressif ESP-C3 module
- Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)
- FCC & CE certified radio module
- Firmware:
- ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).
- Supports upgrading firmware via the web interface (“OTA”)
- Supported in PX4 & Ardupilot
- Protocol: CAN & Serial
- Interface:
- 1x JST GH 4-pin CAN (CAN) port
- 1x JST GH 6-pin TELEM (UART) port
- Antenna Connector type:
- On CNC Case: SMA connector
- On PCB: IPEX Connector
- Range: > 5km detection range*
- Power: 5V supplied from TELEM or CAN port
- LED lights: Bright RGB status LED
- Size:
- Without case: 35.3 x 23.5 mm (not including antenna)
- With CNC case: 38 x 26.5 x 11.5 mm (not including antenna)
- Mount: M2 screws
- Operating temperature: -40°C to +85°C
- Weight:
- PCB only: 4 g
- With CNC case & Antenna: 27.5g
- Without case & Antenna: 16.5g (Cable 20cm)
- Certification: FCC& CE
-
Package Includes：
- 1x Remote ID
- 1x Antenna
- 1x JST GH 6pin 150mm Cable
- 1x JST GH 4pin 150mm Cable
Additional parameters
| Category: | Other accessories |
|---|---|
| Weight: | 0.05 kg |
Be the first who will post an article to this item!
Only registered users may submit ratings. Please log in or sign up.
Be the first who will post an article to this item!
Add a comment